DIN - RAIL Remote Controls Three Phase Energy Meter Modbus 7
Modules Four Wire
- Model YEM021GC three phase four wire electronic DIN rail active
energy meter is a kind of new style three phase four wire active
energy meter, it adopt micro-electronics technique, and imported
large scale integrate circuit, use advanced technique of digital
and SMT techniques, etc.
- The meter completely accord with relevant technical requirements of
class 1 three phase active energy meter stipulated in international
standard IEC 62053-21.
- It can accurate and directly measure 50Hz or 60Hz active energy
consumption from three phase four wire AC electricity net.
- This meter has seven digits LCD displays shows the active energy
consumption. And there are far infrared and RS485 communication
module in it.Contact with all kind of AMR system conveniently.
- It has following features: good reliability, small volume, light
weight, specious nice appearance, convenient installation, etc.
|Reference Voltage(V)||Current Specification(A)||Staring Current(A)|
|0.02A, 0.04A, 0.08A||LCD 6+1/5+2|
AC voltage 4kv for 1 minute,1.2/50us wavefrom
impulse voltage 6kv
- 35mm standard DIN rail installation, complying with standard DIN
EN50022. Or front board installed(mounting holes center distance 63
mm), users can choose any one by themselves.
- Ten pole width (Modulus 12.5mm), complying with standard
JB/T7121-1993.Seven digits display LCD, standard configuration 6+1
digits display (999999.1kWh). May select 5+2 digits display (Please
specified when ordering).
- Standard configuration one port of pulse output
passive(polarity),May select a distant port of pulse output passive
(nonpolarity). And contact with all kind of AMR system
conveniently,Complying with standard IEC 62053-31 and DIN
43864.Four LED instructions respectively every power supply state
and signal of energy impulse.
- Automatic detection the direction of the flow of load current. And
Instructions on individual LED.Single direction three components
measure three phase four wire active energy consumption. It is
nothing with direction of the flow of load current. Complying with
standard IEC 62053-21.
- Standard configuration type S wiring (Inlet from bottom, outlet
from top) for direct connect operation,we can also choose another
type of wiring, and useCT (Product Configuration code is IC) and PT
& CT(Product Configuration code is HC) for operation.Standard
configuration short terminals cover, may select extension terminals
cover, in order to protect to use safety. (Product Configuration
code is JF).